Filter
Top Products
7-42
FUEL INJECTION SYSTEM
Fault code No. Er-4
Symptom Registered data cannot be received from the FI diagnostic tool.
Fail-safe system Able to start
Able to drive
Diagnostic code No. —
FI diagnostic tool dis-
play
—
Checking method —
Item Item/components and probable cause Check or maintenance job Checking method
1 Check the connection and locking con-
dition of the FI diagnostic tool coupler.
Disconnect the coupler and check the
pins. (bent or broken terminals and
locking condition of the pins)
Poor connection → Properly
connect, repair, or replace.
Set the switch on the
FI diagnostic tool sub-
wire harness to "ON",
and then check the
fault code display.
Fault code number
is not displayed →
Service is finished.
Fault code number
is displayed → Re-
fer to item 2.
2 Check the connection and locking con-
dition of the wire harness ECU coupler.
Disconnect the coupler and check the
pins. (bent or broken terminals and
locking condition of the pins)
Poor connection → Properly
connect, repair, or replace.
Set the switch on the
FI diagnostic tool sub-
wire harness to "ON",
and then check the
fault code display.
Fault code number
is not displayed →
Service is finished.
Fault code number
is displayed → Re-
fer to item 3.
3 Continuity of harness Open or short circuit → Re-
place.
Between FI diagnostic tool
coupler and ECU coupler.
(Light green–Light green)
Set the switch on the
FI diagnostic tool sub-
wire harness to "ON",
and then check the
fault code display.
Fault code number
is not displayed →
Service is finished.
Fault code number
is displayed → Re-
fer to item 4.