Filter
Top Products
7-17
FUEL INJECTION SYSTEM
If fault code Nos. 13 and 14 are both displayed, perform the checks and maintenance jobs for
fault code No. 13 first.
4 Installed condition of sensor.
Check that the gap between the crank-
shaft position sensor and the rotor is
0.85 mm.
Check that the sensor is in-
stalled securely and that
there are no pinched
leads.Check that the ECU is
installed securely and that
there are no pinched leads.
Incorrect installation → Re-
install or repair.
Crank the engine and
check the fault code
display.
Fault code number
is not displayed →
Service is finished.
Fault code number
is displayed → Re-
fer to item 5.
5 Defective crankshaft position sensor. Sensor malfunction → Re-
place.
Refer to "CHECKING THE
AC MAGNETO" section.
Crank the engine and
check the fault code
display.
Fault code number
is not displayed →
Service is finished.
Fault code number
is displayed → Re-
fer to item 6.
6 Malfunction in ECU. Replace the ECU.
Fault code No. 12
Symptom No normal signals are received from the crankshaft position sensor.
Fail-safe system Able to start
Able to drive
Diagnostic code No. —
FI diagnostic tool dis-
play
—
Checking method —
Item Item/components and probable cause Check or maintenance job Checking method