Filter
Top Products
5-22
FRONT BRAKE AND REAR BRAKE
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
A. Front
B. Rear
2. Air bleed:
• Brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" section in the CHAPTER
3.
3. Inspect:
•Brake fluid level
Fluid at lower level → Fill up.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" section in the CHAPTER 3.
4. Install:
• Reservoir float (front brake)
• Diaphragm
• Brake master cylinder cap "1"
• Screw (bolt) {brake master cylinder cap} "2"
After installation, while pulling the brake le-
ver in or pushing down on the brake pedal,
check whether there is any brake fluid leak-
ing where the union bolts are installed re-
spectively at the brake master cylinder and
brake caliper.
A. Front
B. Rear
5. Install: (rear brake only)
• Protector "1"
• Bolt (protector) "2"
Screw (bolt) {brake master cylinder
cap}:
2 Nm (0.2 m•kg, 1.4 ft•lb)
Bolt (protector):
7 Nm (0.7 m•kg, 5.1 ft•lb)