Filter
Top Products
4-78
CRANKCASE AND CRANKSHAFT
5. Install:
• Dowel pin "1"
• Right crankcase
To left crankcase.
• Fit the right crankcase onto the left crankcase.
Tap lightly on the case with soft hammer.
• When installing the crankcase, the connecting
rod should be positioned at TDC (top dead
center).
6. Tighten:
• Bolt (crankcase)
Tighten the crankcase tightening bolts in stage,
using a crisscross pattern.
7. Install:
• Timing chain
• Timing chain guide (exhaust side)
• Bolt for timing chain guide (exhaust side))
8. Remove:
• Sealant
Forced out on the cylinder mating surface.
9. Apply:
• Engine oil
To the crank pin, bearing and oil delivery
hole.
10.Check:
• Crankshaft and transmission operation.
Unsmooth operation → Repair.
Bolt (crankcase):
12 Nm (1.2 m•kg, 8.7 ft•lb)
Bolt for timing chain guide (exhaust
side):
10 Nm (1.0 m•kg, 7.2 ft•lb)