Filter
Top Products
5-51
SWINGARM
INSTALLING THE SWINGARM
1. Install:
• Bushing "1"
• Thrust bearing "2"
•Oil seal "3"
• Collar "4"
To swingarm "5".
Apply the molybdenum disulfide grease on the
bushings, thrust bearings, oil seal lips and con-
tact surfaces of the collar and thrust bearing.
2. Install:
• Collar "1"
•Washer "2"
To relay arm "3".
Apply the molybdenum disulfide grease on the
collars and oil seal lips.
3. Install:
• Collar "1"
To connecting rod "2".
Apply the molybdenum disulfide grease on the
collar and oil seal lips.
4. Install:
• Connecting rod "1"
• Bolt (connecting rod) "2"
•Washer "3"
• Nut (connecting rod) "4"
To relay arm "5".
Apply the molybdenum disulfide grease on the
bolt.
5. Install:
• Relay arm "1"
• Bolt (relay arm) "2"
•Washer "3"
• Nut (relay arm) "4"
To swingarm.
• Apply the molybdenum disulfide grease on
the bolt circumference and threaded portion.
• Do not tighten the nut yet.
Nut (connecting rod):
80 Nm (8.0 m•kg, 58 ft•lb)