Filter
Top Products
5-40
HANDLEBAR
5. Install:
• Right grip "1"
• Collar "2"
Apply the adhesive on the tube guide "3".
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
quer thinner.
• Install the grip to the tube guide so that the
grip match mark "b" and tube guide slot "c"
form the angle as shown.
6. Install:
• Collar "1"
• Grip cap cover "2"
• Throttle grip "3"
Apply the lithium soap base grease on the
throttle grip sliding surface.
7. Install:
• Throttle cables "1"
To tube guide "2".
Apply the lithium soap base grease on the
throttle cable end and tube guide cable winding
portion.
8. Install:
• Throttle cable cap "1"
• Screw (throttle cable cap) "2"
After tightening the screws, check that the
throttle grip "3" moves smoothly. If it does
not, retighten the bolts for adjustment.
Screw (throttle cable cap):
4 Nm (0.4 m•kg, 2.9 ft•lb)