Venturer HPS9308 GPS Receiver User Manual


 
- 84 -
8.3.1.2 Selecting a Street or
the Center of the City
Once the city is selected, you
can continue by specifying the
street you are looking for.
Note: As for the street input,
only available letters are active
when entering the rst word
of the street name . All other
letters are inactive and grey.
Selecting the Center of the
City
If you wish to navigate to the
city displayed in the top center
of the screen, just tap done
before entering any letters. The
search result will be the center
point of the city (where its name
is displayed on the map).
Selecting a Street
If you are looking for an address
or an intersection within the
selected city (shown at the top
of the page), you need to rst
enter the street name you are
looking for.
TIP :
If you are looking for an
intersection, choose the street that
has a rare or unusual name rst.
This way you need to enter fewer
letters to get the list of results. You
may also choose the shorter of the
two streets rst. This way it will
be faster to choose the second
one from the list of crossing
streets after the rst street has
been selected.
You can search for both the type
and the name of a road. If you
have the same name appear as
Street, Avenue, Boulevard, Road,
Place and Court, you can get the
result faster by giving the rst
letter of this, too. For example
searching for ‘Pi A’ will result in
Pine Avenue skipping all Pine
NOTE :
This point is not the geometrical
center but an arbitrarily selected
point chosen by the creators of the
map, usually the most important
intersection in a small town or
village, and for larger cities an
important intersection in the city
center.