Filter
Top Products
Chapter 3: Working with Waypoints 63
... using the cursor
1. Move the cursor over the waypoint that you want to erase. The Waypoint soft
keys appear.
2. Press ERASE WAYPOINT.
3. You will then be asked to confirm this. If the waypoint is part of a route, a
warning message also appears.
Press
ENTER to accept, or CANCEL to quit without saving.
Note:
If you place the cursor over a waypoint to which you are currently navigating
(the active waypoint), the STOP GOTO soft key (or STOP FOLLOW if the waypoint is
part of a route) appears. You must stop the goto before removing the waypoint.
... using the waypoint list
1. Press WPTS/MOB.
2. Press the REV & EDIT WAYPOINTS soft key. The Waypoint List appears.
3. Select the desired waypoint in the Waypoint List.
4. Press the ERASE WAYPOINT soft key.
5. You will then be asked to confirm the action. If the waypoint is part of a route,
a warning message also appears.
Press
ENTER to accept, or CANCEL to quit without saving.
Note:
If this is the waypoint to which you are currently navigating (the active way-
point), a warning message appears. You must stop the goto before erasing the way-
point.
CAUTION: Erasing a Waypoint used in a Route
It is possible to erase waypoints that are used in routes. In such
instances, the stored route will join the two waypoints on either
side of the waypoint just erased. Ensure that this altered route
does not present a navigation hazard.
3.6 Controlling How Waypoints are Displayed
When you have placed many waypoints on your system, it may become difficult to
easily interpret chart information. This is particularly the case if you have many
waypoints in a small area.
To designate whether all waypoints or their names are displayed:
1. Press PRESENT... from the main chart screen.
2. Press the SHOW/HIDE WAYPOINTS soft key.
81295.book Page 63 Wednesday, December 20, 2006 2:48 PM