Filter
Top Products
62 A60 Dual Function Display
... by dragging the waypoint to a new position
You can drag a waypoint to a new position using the cursor and trackpad:
1. Place the cursor over the waypoint that you want to move. The Waypoint soft
keys appear.
2. Press MOVE WAYPOINT.
Note:
If you place the cursor over a waypoint to which you are currently navigating
(the active waypoint), the STOP GOTO soft key (or STOP FOLLOW if the waypoint is
part of a route) appears. You must stop the goto before moving the waypoint.
3. Move the cursor to the new location.
4. Press PLACE WAYPOINT to move the waypoint to the new location or
CANCEL to abandon the move.
CAUTION: Moving a Waypoint used in a Route
It is possible to move waypoints that are used in routes. In such
instances, the stored route will include the Waypoint in its new
position. Ensure that this does not present a navigation hazard.
Erasing a Waypoint
You can erase any waypoint on the system using the cursor or the waypoint list
except for the waypoint that you are currently navigating to (see “Navigating to a
Specific Point“ on page 73).
If you attempt to delete any waypoint used in a route, a warning message is
displayed that this is the case. You can override the warning and delete the
waypoint anyway by pressing
ENTER when prompted. After the waypoint is
removed, the route will automatically join the two waypoints on either side of the
waypoint you just deleted. This occurs in all routes that contained the newly
deleted waypoint.
To erase a waypoint:
D9801-1
N 26°16.496
W 080°03.907
WPT 0005
Edit Waypoint
Edit Waypoint
Symbol...
Name...
Latitude...
Longitude...
Comment...
N 26°16.496
81295.book Page 62 Wednesday, December 20, 2006 2:48 PM