Filter
Top Products
Chapter 2: General Operation and System Setup 39
2.11 Display Setup
These options control the appearance of your A60 Display.
Brightness
Use the trackpad (left/right) keys or rotary knob to select the brightness value
from a low of 5% to a high of 100% in 5% increments. The default is 100%. This
setting always resets to 100% at power-up.
Note:
You can quickly access this setting by pressing and releasing the POWER button.
Data Items
Data Items provide regularly used data in a compact form so that most of the
graphics can still be seen. Items are stacked on top of one another. Select ON or
OFF for each item. The default is OFF for all.
Note:
Data is normally acquired from the DSM25. If a DSM25 is not connected, these val-
ues can be obtained from another instrument via NMEA.
• Depth
Measurement from bottom of transducer to the seabed.
•
Speed
Reading from transducer’s paddlewheel. Note that this is not SOG, which
accounts for current, wind or other sea conditions.
•
Temperature
Reading from transducer’s temperature-sensing thermistor.
•
Battery
The boat’s battery voltage.
•
Log
Total distance travelled by the boat.
•
Trip
Distance travelled since the counter was reset, using the Trip Reset option in
the Fishfinder Setup menu.
•
WPT BRG
Bearing to the active waypoint.
•
WPT RNG
Range to the active waypoint.
•
TTG
Estimated time-to-go before reaching the active waypoint.
•
COG
Current course over ground.
81295.book Page 39 Wednesday, December 20, 2006 2:48 PM