Filter
Top Products
90 A60 Dual Function Display
8. Press SAVE ROUTE. The new leg is incorporated into the route.
Note:
If you are adding a waypoint to an active route (a route that you are currently fol-
lowing), the change does not take effect until after you have halted the route by pressing
STOP FOLLOW.
... to remove a waypoint
This option changes the course of a route by removing a waypoint from the route:
1. Access the Make Route screen using the method described in the previous
section “... to add a waypoint”.
2. Use the trackpad (right) to move control from the left (Waypoint) column to
the right (New Route) column.
3. Use the trackpad (up) to highlight the waypoint you want to delete.
4. Press REMOVE WAYPOINT.
5. Press
ENTER. The selected waypoint is removed from the right-hand (New
Route) column but not from the left-hand (Waypoint) column, that is, it is
removed from the route but not actually deleted from the chart. The route
automatically joins the two waypoints on either side of the waypoint you just
deleted. This occurs in all routes that contained the newly-removed waypoint.
Make Route
D9864-1
WPT 0008
WPT 0009
WPT 0010
WPT 0011
WPT 0012
WPT 0013
WPT 0008
WPT 0009
WPT 0010
WPT 0011
N 25 28.205
W 079 39.759
N 25 33.055
W 079 56.151
Make Route
INSERT
WAYPOINT
Make Route
D9865-1
WPT 0008
WPT 0009
WPT 0010
WPT 0011
WPT 0012
WPT 0013
WPT 0008
WPT 0009
WPT 0011
N 25 34.521
W 079 01.755
N 25 33.055
W 079 56.151
Make Route
ENTER
ENTER
then
81295.book Page 90 Wednesday, December 20, 2006 2:48 PM