Filter
Top Products
87
Chapter 4
Utilizing Various Information
2 Push the BACK button.
The previous screen appears.
■Checking the connections of leads and installation positions
Check that leads are properly connected between the main unit and the car. Please also check
whether they are connected in the correct positions.
1 Select “Information” in the Main menu, then select “Location Status” and “Connec-
tion Status”. Click the OK button.
The Connection Status screen appears. Either “OK” or “No good” appears on the screen,
and connection status of each cable is shown.
1.Speed Pulse
The number of the Speed Pulse detected by this unit is shown. “0” is shown while the
car is stationary.
2.GPS Aerial
The connection status of GPS antenna and the sensitivity are shown. If “No good” is
displayed, check the connection status of GPS antenna.
3.Installation Position
The Installation position of the main unit is shown. If “No good” is displayed, refer to
“Installation Manual” for the installation position.
4.Hand brake
When the parking brake is applied, “On” is displayed. When the parking brake is
released, “Off” is displayed. Keep the foot brake on while checking that the parking
brake connection works properly.
5.Power Voltage
The power supply (reference value) provided from the car battery to this unit is shown.
If the voltage does not fall within the range of 11 to 15V, check that power cable con-
nection is correct.
6.Illumination
When the headlights or small lamps of a car are on, “On” is displayed. When the head-
lights of a car are off, “Off” is displayed. (If the ILL (orange/white) lead is not con-
nected, “Off” appears.)
To clear the memory...
If you want to delete the memorised learning contents of “Distance”, “Speed”, or
“Learning Status”, perform the following procedure:
1 Select the item you want to delete, and click the OK button.
2 While “Clear” is highlighted, click the OK button.
2
3
5
6
4
1
7