Filter
Top Products
13-3
OFFSET NAV CANCELLED - Offset navigation has been cancelled due to
a GOTO operation or activation of a new route.
OFFSET NAV IN EFFECT - Offset navigation mode is in effect.
OFST TOO BIG FOR RTE - The parallel track distance is too large for the
active route.
OSC NEEDS ADJUSTMENT - The GPS 100 has detected excessive drift
in its internal crystal oscillator which may result in longer acquisition time.
The unit should be taken to an authorized GARMIN service center as soon
as possible.
POOR GPS COVERAGE - The GPS 100 cannot acquire sufficient satellites
necessary to provide navigation.
PWR DOWN AND RE-INIT - The GPS 100 is unusable until power has been
cycled and the unit re-initialized. Questionable initial UTC date, time or
position may have been entered on the Initialization Page or abnormal
satellite conditions may exist.
PROX ALARM-PRESS NAV - Your craft has penetrated the alarm circle of
a proximity waypoint. Press the NAV key to see the bearing and distance to
the proximity waypoint.
PROXIMITY OVERLAP - The circles defined by two proximity waypoints
overlap. When entering the area of the overlap, the GPS 100 will alarm you
of the closest proximity waypoint, but not both. You should be certain this
condition is desirable.
PROXIMITY WPT MOVED - One or more proximity waypoints were moved
at least 0.33 arc minutes due to a database change.
PROXIMTY WPT DELETED - One or more proximity waypoints were
deleted due to a database change.
READY FOR NAVIGATION - The GPS 100 is ready for navigation.
RECEIVER FAILED - The GPS 100 has detected a failure in the receiver
hardware. If the message persists, the GPS 100 is unusable and should be
taken to an authorized GARMIN service center.