Filter
Top Products
10-4
· Move the cursor over “STOP?” and press the ENT key.
The count down timer may be reset at any time while running or stopped.
When reset, the count down timer value will return to its initial value.
To reset the count down timer...
· Move the cursor over “RESET?” and press the ENT key.
The elapsed timers count up instead of counting down. They do not generate
messages but simply measure time from the point at which they were started.
To start an elapsed timer...
· Move the cursor over the cyclic field on line 3 and press the CLR key
until “ELAPSED TIME” is displayed.
· Move the cursor over “RESET?” and press the ENT key. The elapsed
time will be reset to zero and the cursor will automatically move to
“START?”.
· With the cursor over “START?” press the ENT key to start the elapsed
timer.
You may stop the elapsed timer at any time.
To stop the elapsed timer...
· Move the cursor over “STOP?” and press the ENT key.