Filter
Top Products
A total of 100 user waypoints can be permanently stored in memory. The
number of user waypoints you have defined is shown in the upper right corner
of the page.
To scroll through the waypoint list...
· Place the cursor over the last waypoint name on line 3 and press the
right arrow key to scroll down the list.
· Place the cursor over the first waypoint name on line 1 and press the
left arrow key to scroll up the list.
The Waypoint Catalog Page allows you to delete user waypoints which are
not used in any route and are not members of the proximity list. (NOTE: If
you wish to delete a waypoint that is used in a route or is a member of the
proximity list, first remove it from the route and/or proximity list before
attempting to delete the waypoint.)
To delete a waypoint from memory...
· Place the cursor over the desired waypoint.
· Press the CLR key, the waypoint name will blank.
· Press the ENT key, the waypoint will be deleted from memory.
The Waypoint Catalog Page also allows you to rename user waypoints.
To rename a user waypoint...
· Place the cursor over the desired waypoint.
· Enter a unique waypoint name. If you enter a name that is already
used, you will be informed with the message “WPT EXISTS _____”
(where the blank will be filled in with the waypoint name). Enter a
different waypoint name if this occurs. After entering a unique
waypoint name, the Rename Waypoint Page will be displayed as
illustrated below.
4-12