Filter
Top Products
15-6
· Press the right arrow key until the cursor is over route 1.
· With the cursor over route 1, press the ENT key. You have just
selected the Route Review Page for route 1 as illustrated below.
Notice that the route is empty (it does not contain any waypoints).
· Enter the waypoint name of Fort Meyers Page Field (KFMY). (Hint:
Since your present position was initialized at KFMY, try scanning
through the nearest airport list. Begin by pressing the WPT key with
the cursor over the blank waypoint name as illustrated above and then
select the airport list from the Waypoint Scan Page.)
· Enter the waypoint name of the Dry Tortugas (DRYTG).
· Enter the waypoint name of Key West International (KEYW). (Hint:
Enter the characters KE. Press the WPT key and select the airport
list from the Waypoint Scan Page. You can proceed to scan through
the airport names beginning with KE.)
As you can see, you have just created a route that will take you from Fort
Meyers over the Dry Tortugas and on to Key West! While doing so, you
practiced using the waypoint scanning feature.