Garmin GPS 152 GPS Receiver User Manual


 
10
Getting Started
Marking Waypoints
Marking Waypoints
To mark your present position:
1. Hold down the ENTER/MARK key until the New Waypoint window appears, then release the key.
The window will show a default 3-digit waypoint name/number (001), symbol (dot), and position.
You can leave the name as the auto-assigned number, but for this exercise, change the name
to DOCK.
2. Use the ARROW KEYPAD to highlight the waypoint name eld (001) and press ENTER/MARK.
You will see that just the rst 0 is now highlighted.
3. Press LEFT on the ARROW KEYPAD to clear the name eld.
4. Press the UP or DOWN arrow of the ARROW KEYPAD until the letter D appears, and then press
the RIGHT arrow key to go to the next space to the right, then UP or DOWN again until O appears.
Repeat this until you have entered the name DOCK. If you make a mistake and select an incorrect
character, simply use the LEFT arrow key of the ARROW KEYPAD to backspace the cursor and then
UP or DOWN to correct the entry. (If you accidentally press ENTER/MARK before you are done,
simply press ENTER/MARK again and move the highlight to where you left off.)
5. After you have entered all the letters, press ENTER/MARK to con rm the name.
6. To access the waypoint symbol page, highlight the waypoint symbol eld which is to the left of the
waypoints name and press ENTER/MARK. Note that the default symbol is a dot.
7. You will see an alphabetical list of available waypoint symbols to choose from. You will see a scroll
bar on the right of the window indicating your current position on the entire list of symbols. Press
the ARROW KEYPAD UP or DOWN until you highlight the ANCHOR symbol.
8. Press ENTER/MARK to con rm the ANCHOR symbol.
9. Highlight OK at the bottom of the window and press ENTER/MARK again to con rm the OK
prompt and save the waypoint. You may also highlight Delete and press ENTER/MARK to not
save the waypoint.
The waypoint is now stored in memory. Note that waypoints may also be created graphically with
the Map Page cursor or by manually entering position coordinates. These techniques are described in
the reference section of the manual and/or on the GPS 152 Quick Reference Guide.
Press ENTER/MARK after entering the name.
Choose from a list of 40 useful symbols to
represent your waypoint on the Map Page.
152 Manual Part 1.indd 10 11/27/2002, 2:55:50 PM