Garmin GPS 152 GPS Receiver User Manual


 
5
Getting Started
Initializing the Receiver
,
To graphically initialize the GPS 152:
1. Press the MENU key twice for the Main Menu. Press UP or DOWN on the ARROW KEYPAD until
the GPS tab is highlighted, then press the MENU key once.
2. Using the ARROW KEYPAD, highlight Initialize Position and press ENTER/MARK to initialize
the receiver from the map. The Initialize Position Page will appear, prompting you to select your
approximate location with the map cursor.
3. Use the ARROW KEYPAD to move the map cursor and point to your approximate location within
200 miles. If you have dif culty identifying your position, press and release the IN key to zoom in
to see the next lower map scale.
4. Once you have determined your approximate location on the map, press the ENTER/MARK key.
NOTE: This does not “calibrate” the unit in any way, but rather helps to speed up the
initial satellite acquisition. If the unit switches to the Map Page or displays ‘2D or 3D
Navigation during this process, it is not necessary to initialize the unit.
The GPS 152 will now begin searching for the appropriate satellites for your region and should
acquire a x within a few minutes. When viewing the Satellite Status page, a signal strength bar for
each satellite in view will appear on the top middle of the page, with the appropriate satellite number
under each bar. The progress of satellite acquisition is shown in three stages:
No signal strength bars the receiver is looking for the satellites indicated.
Hollow signal strength bars the receiver has found the indicated satellite(s) and is collecting data.
Solid signal strength bars the receiver has collected the necessary data and the satellite(s) are
ready for use.
Once the receiver has collected information from at least three satellites, the top of the screen will
display either 2D or 3D Navigation, and the GPS 152 is ready for use.
Point to your approximate location
and press ENTER/MARK.
A satellites strength bar will turn black
when its ready for use.
A Lost Satellite Reception message appears
on any screen if the navigation signal is lost.
152 Manual Part 1.indd 5 11/27/2002, 2:55:47 PM