Filter
Top Products
2--32
62--11362
2.3.4 Crankshaft (Continued)
1. Stopper
2. Sleeve Guide
3. Crankshaft Sleeve
4. Auxiliary Socket For
Pushing
5. Crankshaft
2.3.4.g Replacing Crankshaft Sleeve
1. Remove the crankshaft sleeve (3) using a special--
use puller set.
2. Set the sleeve guide (2) to the crankshaft (5).
3. Set the stopper (1) to the crankshaft (5) as shown in
the figure.
4. Heat the new sleeve to a temperaturebetween 150 to
200°C (302to 392°F), and fixthe sleeve o n thecrank-
shaft (5) as shown in the figure.
5. Press fit the sleeve using the auxiliary socket for
pushing (4).
NOTE
Install the sleeve with the largest chamfered
surface facing outward.