Filter
Top Products
2--7
62--11362
2.2.4 Injection Pump and Gear Case (Continued)
2.2.4.b Governor Springs and Speed Control Plate
NOTE
Specific Tool (1): A 1.2mm (.050 inch) diameter
wire with a total length of 200mm (8 inch) with
the tip bent into a hook as depicted in the
illustration is required to hang the governor
springs.
1. Remove the injection pump cover.
2. Remove the speed control p late (7) mounting nuts (3)
and bolts (4).
3. Using the Specific Tool (1), undo the the large
governor spring (5) from the fork lever (2).
4. Set the speed control lever (6) as shown i n the figure.
5. Remove the speed control plate (7), using care notto
let the governor spring (5) disengage from the plate
and fall into the gear case.
1. Specific Tool
2. Fork Lever
3. Speed Control Plate
Mounting Nut
4. Speed Control Plate
Mountin
g
Bolt
5. Large Governor Spring
6. Speed Control Lever
7. Speed Control Plate