Filter
Top Products
8
Accessories
SUPPLIED:
(1) Belt Clip
(1) Carrying Case (P/N GMRGPS-CS)
OPTIONAL:
(1) Desktop Charger (P/N GMRGPS-SC) and
AC/DC Wall Adapter (P/N GMRGPS-WA)
(1) Vehicle Cigarette Lighter Battery Eliminator
(DC12V-to-DC 6V) (P/N GMRGPS-BE)
(1) Car Mounting Bracket (P/N GMRGPS-CB)
(1) Headset (P/N FRS-BHST)
(1) Set of Rechargeable Batteries
Powering the GMR-GPS Unit:
Your GMR-GPS unit operates on four AA batteries. Alkaline batteries will provide slightly better
performance than rechargeable batteries. Only Audiovox-approved rechargeable batteries can be
recharged in the unit using the optional charger. This will ensure optimum performance for the
GMR-GPS. Use of the Audiovox charger with other brands of batteries is not recommended, as
battery charging times will vary. Refer to the manufacturer’s instructions for charging other brands
of batteries.
Installing the Batteries:
Installing batteries in the GMR-GPS unit is straightforward as shown in the illustration below.
1. Simply unlatch the cover clip at the bottom rear of the unit and lift off the battery compart
ment cover.
2. Remove the four discharged batteries, if present, unless the unit is being used for the first
time.
3. Install four rechargeable AA batteries, or install Alkaline batteries, if desired. Carefully note
battery polarity as marked within the battery compartment.
4. Slide the battery compartment cover in place; swing up the cover retaining clip and snap it
into position.
Belt Clip Accessory
CLIP
RELEASE
TAB (PRESS
DOWN)
SPRING
CLIPS
SPRING
LOADED
BELT CLIP
Battery Installation and Removal
BATTERY
COMPARTMENT
COVER
COVER
CLIP (SWING
DOWN)
BATTERY
COMPARTMENT
(OBSERVE
POLARITY)