Filter
Top Products
22
GPS + Radio Standby Page
1. A user identification (ID) code consisting of eight characters maximum. If no user ID
code appears, refer to basic setup mode.
2. The number of acquired satellites. (This could fluctuate depending on clear-sky conditions
or the relative position of the unit’s GPS antenna as it is carried or transported.)
3. The volume level bar graph relative to radio (GMRS) operation. (See
Adjusting the
Volume
.)
4. The current time, either on a 12-hour or 24-hour basis (refer to SETUP mode).
5. The primary GMRS channel number.
6. The GMRS CTCSS sub-code associated with the primary channel number (if one was
previously selected).
GPS Only Standby Page
The GPS ONLY Standby page can be selected from the SETUP page using the MODE function
as previously explained. In addition to depicting satellite acquisition (SEARCHING/NAVIGATION),
this page displays the following information:
1. A user identification (ID) code consisting of eight characters maximum. If no user ID
code appears, refer to basic setup mode.
2. The number of acquired satellites as discussed before.
3. The current date in the format selected from the GPS SETUP menu (DATE FORMAT); this
format can appear as DD-MM-YY, MM-DD-YY or YY-MM-DD.
4. The current time, either on a 12-hour or 24-hour basis (refer to SETUP mode).
GPS + Radio Standby Page
The GPS + RADIO Standby page automatically appears as the default page if the unit is being
turned on for the first time, or if it is selected as the operational mode using the SETUP page. In
addition to depicting satellite acquisition (SEARCHING/NAVIGATION), this page also displays the
following information:
USER
IDENTIFICA-
TION
(ID) CODE
SEARCHING --
-
/NAVIGATION
SATELLITE
ACQUISI-
TION
STATUS
PRIMARY
CHANNEL
(CH) NUMBER
CTCSS
CODE
NUMBER
CURRENT TIME
(12 OR 24
HOUR FOR-
MAT)
16-STEP VOLUME
BAR GRAPH
(USE
UP/DOWN
WHEEL
KEY TO ADJUST)