23
Radio Only Standby Page
The RADIO ONLY Standby page (shown above) can be selected from the SETUP page using the
MODE function as previously explained. Unlike the other two modes which include the GPS
feature, this standby page depicts a radio only display with the following information:
1. A user identification (ID) code consisting of eight characters maximum. If no user ID
code appears, refer to basic setup mode.
2. The volume level bar graph relative to radio (GMRS) operation. (See
Adjusting the
Volume
.)
3. The primary GMRS channel number.
4. The GMRS CTCSS sub-code associated with the primary channel number (if one was
previously selected).
The Gateway Page
To simplify the transition between GPS-related page displays, a Gateway page is provided which
allows you to jump between main pages in the GPS modes (GPS + RADIO and GPS ONLY), rather
than have to scroll through unrelated pages to acquire a desired page. When operating in a GPS
mode, the Gateway page can be acquired from any display. To accomplish Gateway page
acquisition:
1. From any display in either GPS mode, press and hold the PAGE button for at least 2
seconds; the Gateway display will appear, offering any one of six page selections to go to.
2. The title at the top of the Gateway display will differ according to the mode display it was
accessed from; e.g., if the GPS MENU page was in use, a jump to the Gateway page will
result in the Menu page icon being highlighted, and the page title will change to MENU.
3. To access any of the six GPS menu pages from the Gateway page, use the Up/Down wheel
key to highlight the desired page icon; then press Enter to access the page.
4. To return to the Gateway page, simply press and hold the PAGE button for at least 2
seconds.
NOTE: Remember that a momentary press of the PAGE button, whether from the Gateway
page or the current main page will access the next menu page as explained
previously in
Scrolling Through the Menu Pages.
GPS Only Standby Page
Radio Only Standby Page and Volume Function
UP/DOWN
WHEEL KEY