Filter
Top Products
EXPLANATION AND USE OF RADIO SETUP FUNCTIONS
The radio setup functions, as noted earlier, provide ancillary features, such as Roger Beep, Call Tone,
etc.
Dual Channel Selection
In the RADIO setup menu, the first item listed is DUAL CH.
- Highlight this line using the Up/Down wheel key and press Enter.
- A menu appears, listing 10 channels (01-10).
- Highlight the desired channel using the Up/Down wheel key, and press Enter.
When the radio is placed in the dual SCAN mode, this channel will be alternately scanned together
with the priority channel selected from the HOT KEY menu.
Call Tone Selection Mode
The transceiver provides 9 user-selectable call tone melodies (or OFF) to alert you to an incoming
call. To select your favorite call ringer melody:
- From the RADIO setup mode, use the Up/Down wheel key to highlight the desired CALL TONE
number; then press Enter. CALL TONE appears highlighted at the bottom of the display with
the selection displayed.
-Press the Up or Down wheel key switch to select ringer melodies 1-9; at each ringer
selection, the call melody plays. The OFF selection is also available. Select the desired melody
and press Enter.
-The CALL TONE melody has now been selected.
VOX Delay Setting
The VOX delay setting is accessed from the RADIO setup mode using the Up/Down wheel key; then
press Enter. Set the delay for 1-4 SEConds (or OFF) .
The VOX delay time selection setting provides a transmission delay after you have finished speak-
ing. You may need to try different VOX time settings to determine the best value to suit your speak-
ing habits. A longer delay setting will decrease the likelihood of the transmission ending during a
pause in your speech.
Roger Beep Tone
The Roger Beep is a tone which is automatically transmitted whenever the PTT button is released.
This tone alerts the receiving party that the transmission has been terminated intentionally.
To enable and disable the Roger Beep tone:
- From the RADIO setup mode, use the Up/Down wheel key to highlight ROGER BEEP; ROGER
BEEP appears highlighted at the bottom of the display; then press Enter. ON or OFF is
displayed in a menu.
- Press the Up or Down wheel key to select ON or OFF as desired; then press Enter.
- The Roger Beep tone has now been selected On or Off.
Squelch Tail Setting
The squelch tail can be set ON or OFF as desired in the same manner as the Roger Beep tone. Refer
to the Squelch Tail NOTE on the previous page.
42