Section 8: Adjustment Procedures
SATO M10e Service Manual PN: 9001113A Page 8-2
4 Loosen two set screws (not shown) through driver ports (2) of ribbon cover (1).
5 Turn adjustment axle (3) while watching the movement of the print head on the platen roller.
6 When properly positioned, retighten the set screws.
PRINT HEAD ALIGNMENT
Course print head alignment is acheived by loosening the set screw on the left end of the
mounting assembly and manually adjusting the print head forward or backward as deemed
necessary. This can only be acheived while the printer is off and with the print head open. Course
adjustment should only be required if the print position is grossly out of adjustment.
Fine adjustment is achieved by leaving the left set screw secure and loosening the right set
screw. The mounting assembly is designed to allow the print head to eccentrically oscilate when
the right set screw is loosened and the adjustment screw is turned. The adjustment screw is
directly connected to an eccentric cam and provides print head motion. The following procedure
provides instruction on fine adjustment of print head alignment.
1 Set the printer to continuously print test labels and allow several labels to print.
2 Open the top housing cover to expose top frame (1, Figure 8-2) of the print head assembly.
Figure 8-2, Print Head Alignment Adjustment
NOTE: The driver ports of the ribbon cover are aligned with those of the top
frame. Insert a long driver through the driver ports of the ribbon cover and top
frame to the set screw of each port.
NOTE: There are two orifices midway in the axle. Insert something of
sufficient strength into one of the orifices to use as leverage when turning.
There is also a scale on one end of the axle to assist in incremental
adjustment.
4
2
1
3
