Section 7: Replacement Procedures
SATO M10e Service Manual PN 9001113A Page 7-25
1 Switch off the printer and disconnect the power supply cord.
2 Remove top, front, left, and right housing covers to access cutter assembly (1, Figure 7-19).
3 Disconnect all relative wiring harnesses.
4 Remove three screws (2) securing cutter assembly (1) to the printer frame.
5 Remove three screws (3) securing rear cover (4) to cutter assembly (1).
6 Remove four screws (5) securing front cover (6) to cutter assembly (1).
7 Apply front cover (6) to replacement cutter assembly (1) and secure using four screws (5).
8 Apply rear cover (5) to replacement cutter assembly (1) and secure using three screws (3).
9 Position replacement cutter assembly (1) onto the printer frame as design dictates and
secure using three screws (2).
Figure 7-19, Cutter Assembly Replacement
10 Connect all wiring harnesses and test cycle to ensure proper function.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover removal.
3
2
5
2
6
4
1
1
