Section 2: Technical Data
SATO M10e Service Manual PN: 9001113A Page 2-2
Maximum Caliper .008 Inches (0.21 mm)
Maximum Roll Diameter 7.8 Inches (200 mm), Wound face inward
Minimum Core Diameter 3 Inches (76.2 mm)
RIBBON
Maximum Width 10.7 Inches (273 mm)
Length 984 Feet (300 m)
Thickness 4.5 Microns, Wound face inward
SENSING
See-Through Fixed, 0.9 Inches (22.5 mm) left of center
Reflective Eye-Mark Fixed, 0.2 Inches (5 mm) from left label edge.
Continuous Form Sensor not used.
INTERFACE MODULES
Parallel Port IEEE 1284 Standard
Serial Port RS232C (9600 to 57,6000 dps) Standard
RS422/485 (9600 to 57600 bps) Optional
Ready/Busy or X-On/X-Off Flow Control
Bi-Directional Status
Universal Serial Bus USB Version 1.1 Standard
Ethernet 10/100 Base T
PROCESSING
CPU 32 Bit RISC
FLash ROM 4 Mega-Bytes
SDRAM 16 Mega-Bytes
Receive Buffer 2.95 Mega-Bytes
Memory Expansion See Options and Accessories
CHARACTER FONT CAPABILITIES
MATRIX FONTS
U Font 5 dots W x 9 dots H
S Font 8 dots W x 15 dots H
M Font 13 dots W x 20 dots H
XU Font 5 dots W x 9 dots H (Helvetica)
XS Font 17 dots W x 17 dots H (Univers Condensed Bold)
MEDIA
