A SERVICE OF

logo

Open as PDF
next previous
Section 8: Adjustment Procedures
SATO M10e Service Manual PN 9001113A Page 8-7
PAPER GUIDE ADJUSTMENT
When loaded, media stock is centrally oriented on the feed ramp. Media guides located in the
rear of the printer maintain media positioning. The left and right media guides may be adjusted
proportionally in a lateral motion.
1 Loosen purple thumbscrews (1, Figure 8-6) located on left and right media guide (2).
2 Move each guide (2) laterally outward sufficiently to accommodate media width.
3 Load the printer with media stock.
4 Move the guides (2) laterally inward to barely graze the sides of the loaded media.
5 Tighten purple thumbscrews (1) to secure guides (2) into position.
Figure 8-6, Media Guide Adjustment
NOTE: Figure 10-2 of the Diagrams & Schematics section provides guidance
on media loading.
1
2
1
2