Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-24
7 Test cycle to ensure a proper function.
8 Install the right, front, and top housing covers.
Figure 7-18, Ribbon Sensor Replacement
CUTTER REPLACEMENT
The optional cutter assembly is powered by a drive motor directly coupled to a cam configuration
that provides differential movement of an oscillating plate. This plate is attached to the cutter
blade and is its driving force.
Due to repetitive movement, the cutter blade is prone to wear and become dull. Cutting through
the adhesive of continuous labels can accelerate blade wear. If experiencing incomplete cutting
or ragged cut edges, the cutter may require replacement.
The cutter assembly has been designed for equal operational life of all of its components. By the
time that the blade has reached a point as to require replacement, all other components are near
the end of their life expectancy. Thusly, (other than the sensor) the entire cutter assembly is
considered a replaceable part as opposed to its components.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
1
2
3
A
