Section 8: Adjustment Procedures
SATO M10e Service Manual PN 9001113A Page 8-5
ROLLER BELT ADJUSTMENT
1 Switch off power and disconnect power supply cord.
2 Remove the top, front, and right housing covers to gain access to roller belt (1, Figure 8-4).
3 Loosen two screws (2) and manipulate tension roller bracket (3) upward to apply tension to
belt (1).
4 Retighten two screws (2) to secure tension roller bracket (3) and belt (1).
5 Install the right, front, and top housing covers.
Figure 8-4, Roller Belt Adjustment
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover removal.
NOTE: Belt tension should be slightly snug but not tight. Excessive belt
tension will reduce belt life.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
1
3
2
2
