Section 8: Adjustment Procedures
SATO M10e Service Manual PN 9001113A Page 8-9
Figure 8-7, Pitch Sensor Adjustment
10 Remove top, front, and left housing covers for access to main circuit board (1, Figure 8-7).
11 Record all dip switch (2) positions and then switch each to the Off position.
12 Turn the dial of the VR9 potentiometer (3) midway of the scale.
13 Place the DSW2-4 dip switch in the On position.
14 Simultaneously, press and hold the LINE and FEED keys while switching on the power.
15 Release the keys when the printer emits a beep.
16 Place the DSW2-4 dip switch in the Off position.
17 Press the ENTER key to advance to the next display.
NOTE: Perform the remaining steps if it is deemed necessary to adjust the
VR9 potentiometer.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover removal.
LCD DISPLAY: MAINTENANCE MODE
DIPSW2-4 ON>OFF
LCD DISPLAY: FACTORY MODE
LCD DISPLAY: COUNTER MODE
NONE
I
E
E
E
1
2
8
4
+
R
S
B
O
A
R
D
1
3
2
VR3
