A SERVICE OF

logo

Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-6
FEED ROLLER REPLACEMENT
The feed roller is considered to be a high wear component due to its treading against the print
media. This treading will eventually wear grooves into the rubber material and negatively effect
print output.
1 Switch off the printer and disconnect the power supply cord.
2 Remove the top, front, and left housing covers.
3 Remove media stock to provide free access to feed roller (1, Figure 7-5).
Figure 7-5, Feed Roller Replacement
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
NOTE: Figures 10-1 and 10-2 of the Diagrams & Schematics section
provides guidance on housing cover and media removal.
2
4
4,
5
6
3
1
5