Section 5: Printer Configuration
SATO M10e Service Manual PN: 9001113A Page 5-14
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
CARD->MEMORYCOPY
SATOFONT Y/N
This selection allows SATO fonts to be copied from the PCMCIA Memory card
installed in the Memory Card slot.
1. Use the CURSOR keys to step the cursor to desired option. If Yes is
selected, the printer will enter the Card Copy mode. If No is selected, the
display will advance to the Card to Memory Copy All mode.
COPY START
YES NO
2. Confirm the selection by stepping the cursor to the Yes option. If No is
selected, the display will return to the previous selection.
SATO FONT COPY
COPYING
3. Press the ENTER key to select the option. If Yes was selected the copy
process will begin.
SATO FONT COPY
COMPLETED
4. Press the ENTER key to advance to next display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
MEMORY->CARDCOPY
ALL <0MB> Y/N
This selection allows the entire contents from the optional Expanded Memory
to be copied to the PCMCIA Memory card installed in the Memory Card slot.
1. Use the CURSOR keys to step the cursor to desired option. If Yes is
selected, the printer will enter the Card Copy mode. If No is selected, the
display will advance to the Card to Memory Copy All mode.
COPY START
YES NO
2. Confirm by stepping the cursor to the Yes option. If No is selected, the
display will return to the previous selection.
CARD->MEMORY
COPY COPYING
3. Press the ENTER key to select the option. If Yes was selected the copy
process will start.
CARD->MEMORYCOPY
COMPLETED
4. Press the ENTER key to advance to the next display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
MEMORY->CARDCOPY
ALL <0MB> Y/N
This selection allows the entire contents of the optional Expanded Memory to
be copied to the PCMCIA Memory card instaled in the Memory Card slot.
1. Use the CURSOR keys to step the cursor to desired option. If Yes is
selected, the printer will enter the Card Copy mode. If No is selected, the
display will advance to the Card to Memory Copy All mode display.
COPY START
YES NO
2. Confirm the selection by stepping the cursor to the Yes selection. If No is
selected, the display will return to the previous selection.
LCD DISPLAY DEFINITION
