Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-14
POWER SUPPLY FUSE REPLACEMENT
The Printer has two cylindrical fuses that are wired to the power supply. If power is not being
distributed throughout the printer, the fuse may require replacement.
1 Switch off the printer and disconnect the power supply cord.
2 Remove the top, front, and right housing covers to expose power supply (1, Figure 7-11).
3 Unscrew and remove fuse caps (2) along with fuses (3).
4 Remove fuses (3) from fuse caps (2) and determine their condition. Replace as required.
5 Reattach the right, front, and top housing covers.
Figure 7-11, Fuse Replacement
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover removal.
NOTE: The condition of a fuse may be determined by two methods; either by
visually inspecting the fuse filament for voids or by using a meter to
determine conductivity.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
2
3
1
