Section 7: Replacement Procedures
SATO M10e Service Manual PN: 9001113A Page 7-16
DRIVE MOTOR REPLACEMENT
The stepper motor transmits motion to the print mechanism for precise print positioning. The
energized motor provides torque to the label feed roller and the platen roller via a toothed timing
belt configured on pulleys.
1 Switch off the printer and disconnect the power supply cord.
2 Remove the top, front, right, left, and rear housing covers to expose printer frame (1, Figure
7-13).
Figure 7-13, Fuse Replacement
3 Remove seven screws (2) securing printer frame (1) to printer base (3).
4 Carefully lift away printer frame (1) and allow to rest on its front or rear side.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover removal.
NOTE: Ensure the print head assembly is latched closed prior to printer
frame removal.
2
A
B
1
3
5
4
2
