Section 1: Introduction
SATO M10e Service Manual PN: 9001113A Page 1-4
SWITCHES AND INDICATORS
The table below identifies and defines printer switches and indicators for operator interface. The
accompanying graphics display their locations and appearance
Figure 1-3, Front Panel
SWITCHES
Power Switch Two position on/off switch that controls power flow to the system.
Line Key Toggles the printer between the on-line and off-line modes. When
on-line, the printer is ready to recieve data from the host. Acts as a
pause during print by taking the printer off-line. Also used as a scroll
and enter interface for computer setup.
Feed Key Feeds one blank label through the printer when off-line. When the
printer is on-line, another copy of the last label will be printed. Also
used as a scroll and enter interface for computer setup.
INDICATORS
LCD Display Dual line x 16 character display. Used for setting operational param-
eters and displaying error conditions.
Power Indicator Illuminates when the power switch is activated.
Error Illuminates when there is a system fault.
On-Line Illuminates when the system is operating and ready to receive data.
DIP SWITCHES
DSW2 & DSW3 Sets operational parameters of printer.
DSW1 Used to configure optional RS232 communication card.
Line Key
Feed Key
Directional Keys
Enter Key
LCD Display
Power LED
On Line LED
Error LED
