Section 9: Factory Resets
SATO M10e Service Manual PN 9001113A Page 9-3
12 Verify that the counters on the test print have reset to 0.0 km.
13 Power Off the printer and confirm that all switches are in the Off or down position.
CLEAR CUTTER COUNTER
1 Record all dip switch positions.
2 Place all dip switches in the OFF position.
3 Place the DSW2-4 in the ON position.
4 Press and hold the LINE and FEED keys while turning on the power switch.
5 Release the LINE and FEED keys upon hearing a beep.
6 Place the DSW2-4 in the Off position.
7 Press the ENTER key to advance to the next display.
8 Press the CURSOR keys to step from option NONE to option CUT.
9 Press the ENTER key to clear the cutter counter.
10 Use the CURSOR keys to step to the desired option.
WARNING: THIS TEST ACTIVATES ALL THE HEATING ELEMENTS ON
THE PRINT HEAD AND THEREFORE SHOULD BE USED FOR TESTING
PURPOSES ONLY. FULL WIDTH LABELS MUST BE USED TO PREVENT
PRINT HEAD DAMAGE.
CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
LCD DISPLAY: MAINTENANCE MODE
DIPSW2-4 ON->OFF
LCD DISPLAY: FACTORY MODE
LCD DISPLAY: COUNTER CLEAR - NONE
LCD DISPLAY: COUNTER CLEAR - CUT
LCD DISPLAY: PRINT SIZE
SMALL L
ARGE
NOTE: The default selection is large. The CURSOR keys allow scrolling from
one option to another.
