Section 5: Printer Configuration
SATO M10e Service Manual PN: 9001113A Page 5-12
PRINT OFFSET
V:+0000 H:+0000
Vertical Offset is the distance down from the leading edge (the edge of the
label that comes out of the printer first) to the first vertical print position. A
positive setting moves the label edge out of the printer while making it negative
moves it back into the printer. Horizontal Offset is the distance that the label
image is shifted to the right or left on the label. The image is shifted to the left
(towards the inside edge of the label) for a positive setting and it is shifted to
the right (towards the outside edge of the label) for a negative setting. This
setting changes the base reference point for all subsequent label jobs. It’s
effect is identical to the <ESC>A3 Base Reference point command. Since the
printer moves the label in discrete steps equal to the size of the print dot, the
units of measure for Vertical and Horizontal Offset distance is dots. The
maximum values that can be set is 3600 for vertical offset and 3199 for
horizontal. If the allowable limit is exceeded, the printer will not accept the
selection.
1. Use the CURSOR keys to step the cursor to the desired option.
2. Press the ENTER key to select the option and advance to the next display.
3. Repeat step 1 and 2 for character requirement.
4. Press the ENTER key to select the option and advance to the next display.
Note: This setting can be overriden by the Base Reference Point Command.
SET CALENDAR
YES NO
The Calendar is a optional feature in the allowing the date and time to be set
manually using the LCD Display or via the <ESC>WT Calendar Set command.
This screen will not be displayed if the Calendar Option is not installed. The
last setting (manual or software command) received by the printer will be the
value used. The format of the display is YY/MM/DD hh:mm (Year/Month/Day/
hours:minutes). The date format is fixed and cannot be changed. This display
will only appear if the Calendar Option has been installed.
1. Use the CURSOR keys to step the cursor to either the YES or NO option.
The YES option will enable the Calendar feature and NO will disable.
2. Press the ENTER key to select the option and advance to the next display.
CALENDAR
00/00/00 00:00
1. Year - Press the LINE key to increase and the FEED key to decrease the
character value to the desired option. The first display shown will have the
cursor over the two digit year selection. Press the Enter key to select the
option and advance to the Month position.
2. Month - Press the LINE key to increase and the FEED key to decrease the
character value to the desired option. Press the Enter key to select the
option and advance to the Day position.
3. Day - Press the LINE key to increase and the FEED key to decrease the
character value to the desired option. Press the Enter key to select the
option and advance to the Hour position.
4. Hour - Press the LINE key to increase and the FEED key to decrease the
character value to the desired option. The entry must coorespond with a
24 hour day. Press the Enter key to select the option and advance to the
Hour position.
5. Minute - Press the LINE key to increase and the FEED key to decrease
the character value to the desired option. Press the Enter key to select the
option and advance to the Ignore CR/LF display.
LCD DISPLAY DEFINITION
