Section 4: Accessories Installation
SATO M10e Service Manual PN: 9001113A Page 4-2
4 Lift away tear-off plate (2).
5 Place cutter assembly (4, Figure 4-1b) onto printer frame (3).
6 Secure cutter assembly (4) to printer frame (3) using three screws (5).
7 Apply safety switch (6) to front housing cover (7) and secure using screw (8).
Figure 4-1b, Cutter Installation
8 Connect wiring harness (A) from the cutter motor to main board connector (CUTTER).
9 Connect wiring harness (B) from the cutter sensor to main board connector (CUTSEN).
10 Connect wiring harness (C) from the cutter internal switch to safety switch (6).
NOTE: When properly placed, the cutter motor should be oriented on the left
side of the printer and protrude behind the main circuit board.
NOTE: The cutter will be secured with two screws applied to the left end, and
one screw to the right. They will be appied in different orifices on the printer
frame than the dispenser.
NOTE: When properly applied, the safety switch will be mounted to the
interior surface of the front housing cover oriented so that its mounting
orifices are aligned with the orifice in the cover and the mounting pin. The
switch will remain in the open position when mounted.
4
B
5
C
5
8
6
C
3
A
7
