Section 9: Factory Resets
SATO M10e Service Manual PN: 9001113A Page 9-2
11 Press the ENTER key to test print. Press the ENTER key again to stop printing.
12 Verify that the counters on the test print have reset to 0.0 km.
13 Power Off the printer and confirm that all switches are in the Off or down position.
CLEAR HEAD COUNTERS
1 Record all dip switch positions.
2 Place all dip switches in the Off position.
3 Place the DSW2-4 switch in the On or up position.
4 Press and hold the LINE and FEED keys while turning on the power switch.
5 Release the LINE and FEED keys upon hearing a beep.
6 Place the DSW2-4 in the Off position
7 Press the ENTER key to advance to the next display.
8 Use the Cursor keys to step from the NONE option to HEAD.
9 Press the ENTER key to select the HEAD option.
10 Use the CURSOR keys to step to the desired option.
11 Press the ENTER key to test print. Press the ENTER key again to stop printing.
WARNING: THIS TEST ACTIVATES ALL THE HEATING ELEMENTS ON
THE PRINT HEAD AND THEREFORE SHOULD BE USED FOR TESTING
PURPOSES ONLY. FULL WIDTH LABELS MUST BE USED TO PREVENT
PRINT HEAD DAMAGE.
CAUTION: RESETTING THE PRINTER WILL CLEAR ALL REGISTERS.
LCD DISPLAY: MAINTENANCE MODE
DIPSW2-4 ON->OFF
LCD DISPLAY: FACTORY MODE
LCD DISPLAY: COUNTER MODE - NONE
LCD DISPLAY: COUNTER CLEAR - HEAD
LCD DISPLAY: PRINT SIZE -
SMALL L
ARGE
