Section 4: Accessories Installation
SATO M10e Service Manual PN: 9001113A Page 4-4
4 Insert clock chip (3) into the vacant IC Socket (4).
Figure 4-2, EEPROM Installation
5 Connect the power supply cord.
6 Factory Reset as directed in the Factory Reset section of this manual.
7 Press and hold the LINE key while simultaneously switching on the power.
8 When the printer emits an audible beep, release the LINE key.
9 Press the ENTER key repeatedly until the calender option appears on the LCD.
10 Use the CURSOR key to advance the cursor to the YES option.
11 Press the ENTER key to select the option.
NOTE: A properly applied chip will be oriented so that its notched end is
aligned with that of the IC socket.
LCD DISPLAY: INITIALIZING
ROM V00.00.00.00
LCD DISPLAY: ADVANCED MODE
LCD DISPLAY: SET CALENDAR
YES NO
I
E
E
E
1
2
8
4
+
R
S
B
O
A
R
D
1,
4
3
2
