Filter
Top Products
2-48
H The knob section should be positioned in this area.
I Pass the turn signal lead by the outside of the right
side attaching boss of the tail/brake light.
J Pass the turn signal light and license light leads be-
tween the rear side ribs of the battery box assembly
and to the rear part of the vehicle.
K Connect the turn signal lead couplers.
L Connect the license light leads.
M Route the branching lead to the license light behind
the tail/brake light left side attaching boss.
N Route the tail/brake light lead under the projection
part.
O Route the tail/brake light lead above the projection
part.
P There should be no significant difference between
right and left side of the tension rate on the band.
CABLE ROUTING
SPEC
Q Point the opening to the rear side of the vehicle.
R Connect the tail/brake light lead coupler.
S Install the starting circuit cut-off relay to the deepest
position after placing the tail/brake light lead and
turn signal lead in the guide.
T The hook of the battery box assembly should hook
on the surface.
U Route the fuse box lead under the ECU connection
coupler.
V Install the wrapping clamp of the wire harness to the
hole of the battery box assembly.
W Connect the negative lead and the wire harness.