Filter
Top Products
2-44
CABLE ROUTING
SPEC
A To the headlight
B Make sure not to drop the headlight sub wire har-
ness beneath the projection of the duct. Check it
when installing the side cowling.
C Clamp the plastic locking tie to the cover 8. Place
the coupler at the rear side of the vehicle against the
plastic locking tie. Point the tip of the plastic locking
tie to the downward in the inner side of the vehicle.
D Route the head light and meter leads under the
frame’s lower part from the hollow section of the
cover 2.
E Pass the left and right handlebar switch leads out-
side of the air filter case air vent hose.
F Connect the couplers (4 units) at the frame side
hole. Do not catch each lead and wire harness when
the cover 8 is attached.
G From the radiator
H Pass the coolant reservoir tank hose through for-
ward the starter motor lead and speed sensor lead.
I Pass the speed sensor lead coupler and crankshaft
position sensor lead coupler over the throttle stop
cable.
J Pass the fuel tank breather hose and fuel tank drain
hose under the fuel hose.
K To the rear brake light switch lead.
L To the neutral switch
M Insert the wire harness wrapping clamp to the frame
hole.
N Pass the battery negative lead over the wire har-
ness.
O There should be no interference between the wire
harness and the tip of the rear frame attaching bolts.