Filter
Top Products
1-4
FEATURES
GEN
INFO
1 Multi-function display
2 “SELECT” button
3 “RESET” button
4 Engine trouble warning light
NOTE:
INSTRUMENT FUNCTION
Multi-function display
The multi-function display is equipped with the
following:
Sa speedometer (which shows the riding
speed)
San odometer (which shows the total distance
traveled)
Stwo tripmeters (which show the distance
traveled since they were last set to zero)
Sa fuel reserve tripmeter (which shows the
distance traveled since the fuel level warning
light came on)
Sa clock
Sa self-diagnosis device
Sa display brightness and engine speed warn-
ing light control mode
SBe sure to turn the key to “ON” before using the “SELECT” and ”RESET” buttons.
SFor the U.K. only: To switch the speedometer and odometer/tripmeter display between kilometers
and miles, press the “SELECT” button and “RESET” button together for at least two seconds.
Odometer and tripmeter modes
Pushing the “SELECT” button switches the display between the odometer mode “ODO” and the trip-
meter modes “TRIP 1” and “TRIP 2” in the following order:
ODO ! TRIP 1 ! TRIP 2 ! ODO
If the fuel level warning light comes on, the odometer display will automatically change to the fuel re-
serve tripmeter mode “F-TRIP” and start counting the distance traveled from that point. In that case,
pushing the “SELECT” button switches the display between the various tripmeter and odometer
modes in the following order:
F-TRIP ! TRIP 1 ! TRIP 2 ! ODO ! F-TRIP
To reset a tripmeter, select it by pushing the “SELECT” button, and then push the “RESET” button for at
least one second. If you do not reset the fuel reserve tripmeter manually, it will reset itself automatically
and the display will return to the prior mode after refueling and traveling 5 km (3.1 mi).
Clock mode
Turn the key to “ON”.
To change the display to the clock mode, push the “SELECT” button for at least one second.
To change the display back to the prior mode, push the “SELECT” button.
To set the clock:
1. Push the “SELECT” button and “RESET” button together for at least two seconds.
2. When the hour digits start flashing, push the “RESET” button to set the hours.
3. Push the “SELECT” button, and the minute digits will start flashing.
4. Push the “RESET” button to set the minutes.
5. Push the “SELECT” button and then release it to start the clock.