Filter
Top Products
3-48
CHECKING AND ADJUSTING THE STEERING HEAD
CHK
ADJ
WARNING
NOTE:
NOTE:
EAS00146
CHECKING AND ADJUSTING THE
STEERING HEAD
1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
Place the motorcycle on a suitable stand so that
the front wheel is elevated.
2. Check:
Ssteering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness ! Adjust the steering
head.
3. Remove:
Supper bracket
Refer to “HANDLEBAR” and “STEERING
HEAD” in chapter 4.
4. Adjust:
Ssteering head
a. Remove the lock washer
1
, the upper ring
nut
2
, and the rubber washer
3
.
b. Loosen the lower ring nut
4
and then tighten
it to specification with a steering nut wrench
5
.
Set the torque wrench at a right angle to the
steering nut wrench.
Steering nut wrench
90890-01403, YU-33975
Lower ring nut (initial tightening
torque)
52 Nm (5.2 mSkg, 38 ftSlb)