Filter
Top Products
1-5
FEATURES
GEN
INFO
1 Shift timing indicator light
2 “SELECT” button
3 “RESET” button
NOTE:
Display brightness and shift timing indica-
tor light control mode
This mode cycles through five control functions,
allowing you to make the following settings in
the order listed below.
1. Display brightness: This function allows you
to adjust the brightness of the multi-function
display to suit the outside lighting conditions.
2. Shift timing indicator light activity: This func-
tion allows you to choose whether or not the
indicator light should be activated and
whether it should blink or stay on when acti-
vated.
3. Shift timing indicator light activation: This
function allows you to select the shift timing
at which the indicator light will be activated.
4. Shift timing indicator light deactivation: This function allows you to select the engine speed at which
the indicator light will be deactivated.
5. Shift timing indicator light brightness: This function allows you to adjust the brightness of the indica-
tor light to suit your preference.
STo make any settings in this mode, you have to cycle through all of its functions. However, if the key is
turned to “OFF” or engine is started before completing the procedure, only the settings made before
the “SELECT” button was last pushed will be applied.
SIn this mode, the multi-function display shows the current setting for each function (except the shift
timing indicator light activity function).
To adjust the display brightness
1. Turn the key to “OFF”.
2. Push and hold the “SELECT” button.
3. Turn the key to “ON”, and then, after five seconds, release the “SELECT” button.
4. Push the “RESET” button to select the desired display brightness level.
5. Push the “SELECT” button to confirm the selected display brightness level. The control mode
changes to the shift timing indicator light activity function.
To set the shift timing indicator light activity function
1. Push the “RESET” button to select one of the following indicator light activity settings:
a. The indicator light will stay on when activated. (This setting is selected when the indicator light stays
on.)
b. The indicator light will flash when activated. (This setting is selected when the indicator light flashes
four times per second.)
c. The indicator light is deactivated; in other words, it will not come on or flash. (This setting is selected
when the indicator light flashes once every two seconds.)
2. Push the “SELECT” button to confirm the selected indicator light activity. The control mode changes
to the shift timing indicator light activation function.