Filter
Top Products
2-39
CABLE ROUTING
SPEC
1 Throttle stop screw
2 Coolant reservoir tank hose
3 Crankshaft position sensor lead
4 Rear brake light switch lead
5 Water pump inlet hose
6 Clutch cable
7 Coolant hose protector
8 Hose clamp assembly
9 Hose clamp
A Pass the rear brake light switch lead outside of rear
engine mount bolt.
B Pass the ignition coil lead outside of the radiator
hose.
C Pass the coolant reservoir tank hose under the
frame and right side of the throttle body.
D Pass the clutch cable inside of the coolant reservoir
tank hose and radiator return hoses.
E The punch mark starting point should be lower than
the clamp’s top end.
However, the aiming position of the punch mark
starting point should be 5 mm (0.20 in) below the
clamp’s bottom end.
F Pass the clutch cable inside of the radiator hose.
G Assemble as “ ” shown below when clamping.
H Tip of the plastic locking tie shall be pointed to the
inner side at the rear part of the vehicle.
I Clamp the clutch cable so that it is positioned in this
range.
J Clamp the clutch cable by routing the upper end of
the clamp along with the bottom end of the hose
clamp assembly.
a