Filter
Top Products
2-38
J Install the relay to the rib of the headlight.
(Location for the left and right relays is alternative.)
K To the wire harness
L To the front turn signal/position light (right)
M Set the sub wire harness in the joint.
N Do not catch the sub wire harness when the duct is
assembled.
O To the front turn signal/position light (left)
P Point the tip of the plastic locking tie to the front side
of the vehicle. Cut the tip leaving 2 X 10 mm (0.08
X 0.39 in).
Q Point the tip of the plastic locking tie under the under
bracket and rear side of the vehicle. Cut the tip leav-
ing 2 X 10 mm (0.08 X 0.39 in).
CABLE ROUTING
SPEC
F Pass the horn lead by the outside of the throttle
cables and clamp it to the forefront of upper face of
the under bracket. And then route it under the front
brake hose and clamp it to the pawl of the under
cover.
G Clamp it at the position of 40 X 60 mm (1.57 X 2.36
in) from the upper face of the under bracket with the
plastic locking tie. Cut the surplus part of the clamp
tip leaving 2 X 4 mm (0.08 X 0.16 in). Point the tip
of the clamp to the outside of vehicle.
H Pass the throttle cables inside the front brake
hoses.
I Set in the coupler between the head light’s hollow
section and the duct.