Filter
Top Products
3 Setting up the Receiver
28 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Operation
3.1 Other System Components
This section describes optional components that you can use with the
5700 receiver.
31.1 Radios
Radios are the most common data link for Real-Time Kinematic (RTK)
surveying. The 5700 receiver is available with an optional internal radio
in either the 450 or 900 MHz UHF bands. You can also connect an
external radio to Port 3, whether the internal radio is installed or not.
The 5700 receiver supports the following Trimble base radios when
using the internal receiver radio:
• TRIMMARK™ 3
• TRIMMARK IIe
• TRIMTALK™ 450S
• SiteNet™ 450
• SiteNet 900
Internal Radio Setup
You can configure the receiver’s optional internal radio using any of the
following:
• the GPS Configurator software
• the WinFlash software
• the Trimble Survey Controller software
For more information, refer to the GPS Configurator Help, the
WinFlash Help, or the Trimble Survey Controller User Guide.
By default, the internal UHF radio has only a few frequencies installed.
Use the WinFlash software to configure additional frequencies. For
more information, see Adding frequencies for the 450 MHz internal
radio, page 69.