Filter
Top Products
5700/5800 GPS Receiver User Guide 145
Default Settings 18
5800 GPS Receiver Operation
18.2Resetting to Factory Defaults
To reset the 5800 receiver to its factory defaults, do one of the following:
• Press and hold down [P] on the 5800 receiver for 15 seconds.
• In GPS Configurator select the General tab and then click Reset
Receiver
.
182.1 Default behavior
The factory defaults specified above are applied whenever you start the
receiver. If a Power Up file is present in the receiver, its settings are
applied immediately after the default settings, so you can use a Power
Up file to define your own set of defaults.
Input Setup: Station Any
NMEA/ASCII (all messages) All Ports Off
Streamed output All Types Off
Offset = 00
RT17/Binary All Ports Off
Reference position: Latitude 0°
Longitude 0°
Altitude 0.00 m HAE
Antenna: Type 5800 Internal
Height (true vertical) 0.00 m
Group All
Measurement method Bottom of mount
Table 18.1 Default settings (Continued)
Function Factory default